Answering call by voice
co
mmand
This feature allows you to answer incoming
calls automatically by voice. When the voice
command is detected, the speakerphone
mode is turned on. You can turn this feature
on/off. The default setting is “Off”.
The answer by voice command feature
functions as below:
R When the handset is on the base unit:
– only the handset performs voice
detection.
– base unit will not ring nor announce the
caller’s information to avoid interfering
with voice detection.
– when lifting the handset (auto talk is set
to “Off”) from the base unit while
receiving an incoming call, the base unit
starts ringing, announcing the caller's
information and detecting voice.
R When the handset is far from the base unit:
– both the base unit and the handset
perform voice detection.
R In case of multiple units:
– the unit which detects voice the earliest
will receive the call.
– when answering a call manually using a
unit, answer by voice command feature
will end.
– when answering a call by voice
command using a unit, another unit still
can answer manually by pressing M
N
on
the handset or MZN on the base unit.
The call will switch to a conference call if
call sharing mode is set to “On”
(page 55).
Important:
R When setting answer by voice command to
“On”, use ONLY “Tone 1” to “Tone 5”
as your ringer tone. If other ringer tone is
selected, the unit will automatically use
default ringer tones. (Landline: “Tone 1”,
CELL 1: “Tone 2”, CELL 2: “Tone 4”)
Note:
R You can answer calls using voice
commands in any ambient noise.
R For best performance, answer the call
w
ithin a range of 50 cm (20 inches) to 1 m
(40 inches).
R Calls are automatically disconnected in 5
minutes.
R You may hear a warning tone and the unit
may prompts you to press * to continue
talking 1 minute before disconnecting.
R Even if you perform any key operation
during a call, the call is continued
R This feature is not available while baby
monitor is set to “On”.
R The setting you made is common for all line
(landline and cellular lines).
Turning answer by voice command
on
/off
Handset / Base unit
1 MMENUN#106
2 MbN: Select the desired setting. a
MSELECTN
3 MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Setting voice command sensitivity
Yo
u can adjust the sensitivity of voice
command detection. Increase or decrease the
sensitivity to adjust the sound level needed to
trigger the answer by voice command feature.
Handset / Base unit
1 MME
NUN#107
2 MbN: “Sensitivity level” a
MSELECTN
3 MbN: Select the desired setting. a
MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
For assistance, please visit http://shop.panasonic.com/support
35
Answering Call by Voice Command
To Next Page
Loading...
