Call block
Y
ou can press the MCALL BLOCKN button in the
following situations to disconnect the current call
and add a phone number to the call block list:
– when an incoming call is being received
– when an incoming call is being recorded by the
answering system
– when talking on an outside call
Once a phone number has been added to the call
block list, the unit will block calls from that phone
number in the future.
Handset / Base unit
1 P
ress MCALL BLOCKN under the situations
shown above.
2 Confirm the call block number and press
MYESN.
R The call block number is stored in the call
block list, confirmation tone sounds
*1
and
“Call blocked” is displayed, and then
the call is disconnected.
*1 Confirmation tones are used with permission
of © 2018 Copyrights Vision Inc.
Note:
R If the call has no phone number, the call is
blocked but it is not stored in the call block list.
R The call block feature is not available:
– for intercom calls or calls received by call
waiting.
– when a landline call (or cellular call) is being
received during a cellular call (or landline call).
R Blocked calls are logged in the caller list.
Storing unwanted callers
T
he unit can block calls by storing the desired
items in the call block list beforehand (Caller ID
subscribers only).
– “Block a single number”: The unit blocks
calls from specific phone numbers stored in the
call block list.
– “Block range of numbers”: The unit
blocks calls that begin with a number stored in
the call block list, such as a toll-free phone
number prefix or certain area codes.
– “Block unknown CID”: The unit blocks calls
that have no phone number.
Single phone numbers and ranges of numbers can
b
e stored in the call block list up to 1,000 items in
total.
Blocking unwanted callers:
When a call is received, the unit will not ring while
caller information is being received.
*1
If the caller’s phone number matches an entry in
the call block list, the unit emits no sound to the
caller, and disconnects the call.
*1 If you want the first ring to sound, select “Yes”
in “Turning the first ring on/off” (page 33).
Storing a single phone number
I
mportant:
R We recommend storing 10 digits (including the
area code). If only 7 digits are stored, all
numbers that have the same last 7 digits will be
blocked.
Adding call blocked numbers from the caller
l
ist
Handset
n W
hen a cellular phone is paired:
1 MCN CID
2 MbN: Select the desired entry to be blocked.
R To edit the number: MSELECTN a Press
* (Edit) repeatedly until the phone
number is shown in the 10-digit format.
a MSAVEN a MbN: “Call block” a
MSELECTN a Go to step 4.
3 MCALL BLOCKN
4 MbN: “Yes” a MSELECTN
5 Edit the phone number if necessary (24
digits max.). a MSAVEN a MOFFN
n When a cellular phone is not paired:
1 MCN CID
2 MbN: Select the desired entry to be blocked.
R To edit the number: MMENUN a MbN:
“Edit” a MSELECTN
Press MEDITN repeatedly until the phone
number is shown in the 10-digit format.
a MSAVEN a MbN: “Call block” a
MSELECTN a Go to step 4.
3 MCALL BLOCKN
4 MbN: “Yes” a MSELECTN
5 Edit the phone number if necessary (24
digits max.). a MSAVEN a MOFFN
32
For assistance, please visit http://shop.panasonic.com/support
Call Block
To Next Page
Loading...
