Y
Programming using the Handset
30
Document Version 2010-07
Important:
L We recommend setting with your administrator.
Contact your administrator for further
information.
L If this feature is set on your unit, it may be
overridden by your phone system settings.
L This feature is not available on shared lines.
L The call is logged in the caller list (page 42) with
Q after the call is rejected.
1 1 (centre of joystick)
2 {V}/{^}: “IP Service” i M
3 {V}/{^}: “Call Features” i M
4 {V}/{^}: “Do Not Disturb” i M
5 Proceed with the desired operation.
■ When 1 line is registered:
Go to step 6.
■ When 2 or more lines are registered:
{V}/{^}: Select the desired line. i M
6 {V}/{^}: Select “On” or “Off”. i M i
{i}
Block anonymous calls
This feature allows the unit to reject calls when the
unit receives a call without phone number.
The default setting is “Off”.
Important:
L We recommend setting with your administrator.
Contact your administrator for further
information.
L This feature is not available on shared lines.
L The call is logged in the caller list (page 42) with
Q after the call is rejected.
1 1 (centre of joystick)
2 {V}/{^}: “IP Service” i M
3 {V}/{^}: “Call Features” i M
4 {V}/{^}: “Block Anonymous” i M
5 Proceed with the desired operation.
■ When 1 line is registered:
Go to step 6.
■ When 2 or more lines are registered:
{V}/{^}: Select the desired line. i M
6 {V}/{^}: Select “On” or “Off”. i M i
{i}
Incoming call barring (Caller
ID service users only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want to
answer such as junk calls.
When a call is received, the unit does not ring while
the caller is being identified. If the phone number
matches an entry in the call barred list, the unit
rejects the call.
Important:
L When the unit receives a call from a number that
is stored in the call barred list, the call is logged
in the caller list (page 42) with 7 after the call is
rejected.
Storing unwanted callers
You can store up to 30 phone numbers in the call
barred list by using the caller list or by entering the
numbers directly.
Important:
L It is advised to store the phone number with an
area code for PSTN calls in the call barred list.
From the caller list:
1 \ (left soft key)
2 {V}/{^}: Select the entry to be barred. i 1
3 {V}/{^}: “Add Bar List” i M
4 {V}/{^}: “Yes” i M i {i}
By entering phone numbers:
1 1 (centre of joystick) i {#}{2}{1}{7} i
~
2 Enter the phone number (24 digits max.). i
M
L To erase a digit, press ^.
3 {i}
Viewing/editing/erasing bar call
numbers
1
1 (centre of joystick) i {#}{2}{1}{7}
2 {V}/{^}: Select the desired entry.
L To exit, press {i}.
3 Proceed with the desired operation.
■ Editing a number:
1 i {V}/{^}: “Edit” i M i Edit
the phone number. i M i {i}
To Next Page
Loading...
