Useful Information
51
Document Version 2010-07
Base unit (KX-TGP500)
1
Remove the base unit stand by pushing (A)
and sliding down (B).
2 Mount the base unit by inserting the screws
(not supplied) into the round openings on the
unit, then slide the unit down to secure it.
Note:
L Make sure that the wall is strong enough to
support the weight of the unit.
To attach the base unit stand
Place the base unit stand by fitting the tab into the
slot on the base unit. Then slide the stand until it
clicks.
B
A
83 mm
Longer than
20 mm
Space
(2 mm)
Screws
To Next Page
Loading...
