Panasonic KX-TGP550 - System Installation Procedures; Installation Overview; Registering Mobile Handsets

2
2. Installation
2.1. Overview
Before you begin using your new Panasonic DECT system, we would like to provide you with a brief
overview of the steps required for installation.
1. Add DECT base (KX-TGP550) on the administration portal.
2. Add DECT mobile handsets (KX-TPA50) on the administration portal.
3. Add extension for DECT base and DECT mobile handsets on the administration portal and assign
the respective end device.
4. Register mobile handsets to base.
5. Done!
Detailed description are on the administration portal.
2.2. Registering mobile handsets to the DECT base
Your base telephone is automatically registered. During the final step, you must register the mobile
handset to the base. This is done using the menu of your Panasonic mobile handset.
1. To do so, open the main menu of your mobile handset (Joystick).
2. Then select menu item “Initial settings”.
3. Next, select “Registration”.
4. Now select “Register mobile handset”.
Alternatively, instead of steps 1 to 4 you may also proceed as follows:
Press the menu key (Joystick) .
5. On the DECT base press and hold for approx. 4 seconds, then “OK” on the mobile handset.
The mobile handset now scans for the DECT base.