6
Status Indicator of the DECT base station
The indicator flashing patterns are as follows:
slow flashing: 1 time per second
quick flashing: 4 times per second
Status Meaning
Colour Light Pattern
Green On - The base station is connected to the internet. The startup process is
complete and you may now make and receive internet calls.
Slow flashing - The base station is being used for a call.
- The base station is downloading data. Do not disconnect the Ethernet
cable or AC adaptor from the base unit until the STATUS indicator stops
flashing and lights in steady green.
Quick flashing - The handset/desk phone is busy.
Red On - When the base station is turned on, the STATUS indicator lights in red
for about 40 seconds.
Slow flashing - The base station is registering a handset/desk phone.
Quick flashing - The base unit is paging handsets/desk phones (by using the handset
locator button).
Amber On - The base station's IP address may conflict with the IP addresses of the
other devices on your local network. Contact your administrator for
further information.
Slow flashing - The base station is obtaining an IP address or is obtaining
configurations. Please wait.
- The base station is registering with your phone system. Please wait.
- If the STATUS indicator continues flashing, check the following:
• Network settings may not be correct. Contact your administrator.
• Many installation issues can be resolved by resetting all the
equipment. First, shut down your modem, router, hub, base station,
computer.
• If you cannot access Internet Web pages using your computer, check
to see if your phone system is having connection issues in your area.
• For more troubleshooting help, contact your administrator.
Quick flashing - Unplug the base station's AC adaptor to reset the unit, then reconnect
the AC adaptor. If the STATUS indicator is still flashing rapidly, there
may be a problem with the base station hardware. Contact your phone
system dealer/service provider.
Slow switching
(Red⇒Green⇒Amber⇒Off)
- The base station is in maintenance mode. Turn the base station off and
then back on again.
Quick switching
(Red⇒Green⇒Amber⇒Off)
- The base station is restarting. Wait a moment.
Off - - The base unit power is off.
- The Ethernet cable is not connected properly. Please connect it.
- Your network devices (hub, router, etc.) are turned off. Check the LEDs
for the link status of the devices.
To Next Page
Loading...
