Using the Caller List
26
For assistance, please visit http://www.panasonic.com/phonehelp
If the Direct Dial button selected is
occupied, the display on the right will
be shown.
To overwrite, press [OK] (Yes key).
To select the other empty Direct Dial
memory, press [
3] (No key), press an
empty Direct Dial button by pressing
[M1], [M2] or [M3] (Save key).
• A long beep sounds.
• After a few seconds, the display will return
to the Caller List. You can continue storing
other items. To exit the Caller List, press
[EXIT] or wait for 60 seconds.
• To erase other stored items from the Direct Dial memory, see page 35.
• To cancel during programming, press [EXIT]. Start again from step 1.
• You cannot store caller information in the Direct Dial memory if a phone number is
not displayed.
M1 is occupied
Overwrite ?
[
3
] =No [OK]=Yes
TS600W.book Page 26 Friday, October 28, 2005 2:10 PM
To Next Page
Loading...
