Panasonic KX-TS600W - Erasing Stored Numbers; Dialing from Direct Dial Memory

35
Advanced Operation
For assistance, please call: 1-800-211-PANA(7262)For assistance, please visit http://www.panasonic.com/phonehelp
If the Direct Dial button selected is
occupied, the display on the right will
be shown.
To overwrite, press [OK] (Yes key).
To select other empty Direct Dial
memory, press [
3] (No key), press an empty
Direct Dial button ([M1], [M2] or [M3]).
• A long beep sounds.
• To continue storing other items, repeat from step 2.
• To exit the programming mode, press [EXIT] or wait for 60 seconds.
• To erase other stored items from the Direct Dial memory, see below.
• When using the Call Restriction feature (p. 40), you cannot store a phone number
in the Direct Dial memory ([M1], [M2] or [M3]).
• You can exit the programming mode any time by pressing [EXIT].
• If a pause is required for dialing, press [PAUSE] where needed. If required, you
can also store [FLASH] in a phone number. Pressing [PAUSE] or [FLASH]
counts as one digit (p. 36, 38).
To erase a stored number
1
Press the required Direct Dial button
([M1], [M2] or [M3]).
2
Press [ERASE].
• To stop erasing, press [3] (No key).
3
Press [OK] (Yes key).
• A long beep sounds.
• To exit the programming mode, press [EXIT]
or wait for 60 seconds.
Dialing
1
Lift the handset or press [SP-PHONE/HEADSET].
2
Press the required Direct Dial button ([M1], [M2] or [M3]).
• The stored number is displayed and dialed.
OR
1
Press the required Direct Dial button ([M1], [M2] or [M3]).
• The stored number is displayed.
2
Lift the handset or press [SP-PHONE/HEADSET].
M1 is occupied
Overwrite ?
[ 3 ]=No [OK]=Yes
Erase ?
[
3 ]=No [OK]=Yes
Erased
Memory Empty
TS600W.book Page 35 Monday, November 7, 2005 10:47 AM