Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
I cannot hear a dial tone
I cannot use the Smart function
key even if the indicator is
flashing slowly.
The base unit beeps.
Menu list
Problem
The display is in a language I
cannot read.
I cannot register a handset to a
base unit.
Cause/solution
Place the handset on the base unit or charger to turn on
the handset.
Make sure the batteries are installed correctly (page 10).
Fully charge the batteries (page 11).
Check the connections (page 10)
Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
The handset has not been registered to the base unit.
Register the handset (page 35).
The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our service
personnel to have the unit repaired. If the working
telephone does not operate properly, contact your service
provider/telephone company.
Another unit is in use. Wait and try again later.
New messages have been recorded. Listen to the new
messages (page 40)
Cause/solution
• Change the display language (page 14).
• The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 35)
For assistance, please visit http://www.panasonic.com/help
51
To Next Page
Need help?
General
