169
11. Using the Wi-Fi function
[Wi-Fi Setup] Menu
Configure the settings required for the Wi-Fi function.
The settings cannot be changed when connected to Wi-Fi.
You can improve security by enabling password entry for a direct connection to a
smartphone.
• When [ON] is selected, you can also set up a connection by scanning a QR code.
You can set the workgroup.
To send images to a PC, a connection to the same workgroup as the destination PC is
required.
(The default setting is “WORKGROUP”.)
• If you are using the PC with standard settings, you do not need to change the workgroup.
You can change the name (SSID) of this unit.
1 Press [DISP.].
2 Enter the desired device name.
• For information on how to enter characters, refer to P44.
• A maximum of 32 characters can be entered.
> [Setup] > [Wi-Fi] > [Wi-Fi Setup]
[Wi-Fi Password]
[ON]
Connects the camera and a smartphone using an SSID and
password. (P153)
[OFF] Connects the camera and a smartphone using an SSID. (P152)
[PC Connection]
[Change Workgroup
Name]
Enter the workgroup of the connecting PC.
• For information on how to enter characters, refer to P44.
[Restore to Default]
Restores the default state.
[Device Name]
MENU
To Next Page
Loading...
Need help?
General
