Preparation/Basic
13
(ENG) DVQX1546
3 After the final screen (12/12), press [MENU/SET] to finish.
• When [MENU/SET] is pressed after the final screen (12/12), [Precautions] is not
displayed from the next time the power is turned on.
• This can also be viewed from [Precautions] in the [Setup] menu.
1 Check that there are no foreign objects on the inner side of the side
door.
• If there is any foreign object, such as lint, hair, sand, etc., on the surrounding area,
water will leak within a few seconds, causing malfunction.
• Wipe it off with a soft, dry cloth if there is any liquid.
It may cause water leaks and malfunction if you use the camera with liquid
adhered.
• If foreign objects are present, wipe them off with a dry, lint-free cloth.
• Be extremely careful to remove the small sand etc. that may adhere to the sides
and corners of the rubber seal.
2 Check for cracks and deformation of the rubber seal on the side door.
• The integrity of the rubber seals may decrease after about 1 year, with use and
age. To avoid permanently damaging the camera, the seals should be replaced
once each year. Please contact Panasonic for related costs and other information.
Check before using underwater
Always wipe the rubber seal on the side door and the area where rubber
seal sits with a dry, lint-free cloth.
DC-FT7-TS7GN-DVQX1546_eng.book 13 ページ ２０１８年５月１０日 木曜日 午後３時４分
To Next Page
Loading...
Need help?
General
