422
14. Wi-Fi/Bluetooth
[From List]
Searches for a wireless access point to use, and connects to this.
• Confirm the encryption key of the wireless access point.
Select the wireless access point you
are connecting to.
• Press [DISP.] to run a wireless access point
search again.
• If no wireless access point is found, refer to
“Connecting by Manual Input” on page 422.
(If network authentication is encrypted)
Enter the encryption key.
Connecting by Manual Input
• Check the SSID, network authentication, encryption, and encryption key of
the wireless access point you are using.
In the screen in Step of “[From List]”, select [Manual Input]. (422)
Enter the SSID of the wireless access point you are connecting to, and
then select [Set].
Select the network authentication.
[WPA2-PSK]
Supported encryption: [TKIP], [AES]
[WPA2/WPA-PSK]
[No Encryption] —
(When other than [No Encryption] is selected)
Enter the encryption key and then select [Set].
To Next Page
Loading...
