65
Recording
(ENG) DVQX1072
Recording Motion Pictures Using a Connected
External Device
You can connect the camera’s [HDMI] socket and an external monitor or recorder with an
HDMI cable. HDMI output is controlled separately for recording and playback. This section
describes the HDMI output control for recording.
• Playback signals are output using the [HDMI Mode (Play)] setting in [TV Connection] of the
[Setup] menu.
• Use a “High Speed HDMI cable” with the HDMI logo.
Cables that do not comply with the HDMI standards will not work.
“High Speed HDMI cable” (Type A–Type A plug, up to 1.5 m (4.9 feet) long)
∫ Attaching the cable holder
Attach the cable holder to prevent the HDMI cable or USB connection cable from getting
disconnected by accident or the [HDMI] or USB socket from being damaged.
• Example: Attaching to an HDMI cable
1 While pushing A (1), slide the clamp
portion of the cable holder to remove it
(2).
2 After placing the camera on a stable
surface, loosely mount the cable holder
to the mount on the camera (3), and
secure the cable holder by rotating the
screws in the direction of the arrows (4, 5).
3 Attach the HDMI cable to the clamp
portion (6).
4 Slide the clamp portion to attach it to
the cable holder (7).
External monitor/recorder (HDMI output during recording)
A [HDMI] socket (Type A)
B HDMI cable
C External recorder
D External monitor
DC-GH5BodyGN-DVQX1072_eng.book 65 ページ ２０１７年２月１３日 月曜日 午前１１時４５分
To Next Page
Loading...
Need help?
General
