2. Getting Started – Charging the Battery
58
• To recover from [Sleep Mode], [Sleep Mode(Wi-Fi)], or [Power Save LVF Shooting],
perform one of the following operations:
– Press the shutter button halfway.
– Set the camera on/off switch to [OFF] and then [ON] again.
• To recover from [Auto LVF/Monitor Off], press any button.
• [Power Save Mode] is not available in the following cases:
– While connected to a PC or printer
– During video recording/video playback
– When recording with [6K/4K Pre-Burst]
– During a [Time Lapse Shot]
– When recording with [Stop Motion Animation] (when [Auto Shooting] is set)
– When recording with [Multiple Exposure]
– When recording with [Focus Transition]
– During a [Slide Show]
– During HDMI output for recording
To Next Page
Loading...
