2. Getting Started – Charging the Battery
57
[Power Save Mode]
This is a function to automatically turn the camera to sleep (power save)
status or turn off the viewfinder/monitor if no operation is performed for a
set time. Reduces battery consumption.
[ ] [ ] Select [Power Save Mode]
[Sleep Mode] Sets the amount of time until the camera is put to sleep.
[Sleep
Mode(Wi-Fi)]
Sets the camera to sleep 15 minutes after being disconnected
from Wi-Fi.
[Auto LVF/
Monitor Off]
Sets the amount of time it takes for the viewfinder/monitor to turn
off.
(The camera is not turned off.)
[Power Save
LVF Shooting]
Puts the camera to sleep when the recording screen is being
displayed on the monitor when automatic viewfinder/monitor
switching is active.
[Time to Sleep]
Sets the amount of time until the camera is
put to sleep.
[Method of
Activation]
Sets the screen where the camera is put to
sleep.
[Only Control Panel]:
Puts the camera to sleep only when the
control panel (Switching the Display
Information: 88) is displayed.
[While Recording Standby]:
Puts the camera to sleep from any screen
during recording standby.
To Next Page
Loading...
