23
Preparations
Charging battery
Inserting the battery
To charge the battery, insert it into the camera.
1
Slide the release lever to the [OPEN]
position and open the card/battery door
Release lever
[OPEN]
[LOCK]
2
Insert the battery all the way
• Insert the battery all the way firmly and
check that it is locked by lever.
3
Close the card/battery door and then
slide the release lever to the [LOCK]
position
Make sure to insert the battery in the correct
orientation (
).
Lever
■
To remove battery
Move the lever in the card/battery
compartment in the direction of the arrow.
●
Always use genuine Panasonic batteries.
●
If you use other batteries, we cannot guarantee the quality of this product.
●
If you close the card/battery door with the battery not inserted all the way, the battery may pop out.
●
To remove the battery, turn the camera off and wait until the LUMIX indicator on the screen goes
off. (Failure to wait may cause the camera to malfunction and may damage the card or recorded
data.)
●
Remove battery from camera after use.
To Next Page
Loading...
Need help?
General
