37
DVQX1391 (ENG)
Recording
4
Press the shutter button to perform recording
• When you press the [Fn1] button while recording, you can add a marker. (Up
to 40 markers for each recording.) When selecting and saving pictures from
a 4K burst file, you can skip to the positions where you added markers. ([4K
Burst(S/S)] only)
• Burst pictures are saved as a single 4K burst file in the MP4 format.
• When [Auto Review] is enabled, the picture selection screen will be displayed
automatically.
■
Setting Pre-Burst Recording ([4K Burst]/[4K Burst(S/S)])
The camera starts recording approximately 1 second before the shutter button is
pressed fully, so you will not miss a photo opportunity.
→ [Rec] → [4K PHOTO] → [Pre-Burst Recording] → [ON]
• Auto Focus operation settings and menus that cannot be set while this function
is in use are the same as those during [4K Pre-Burst] operation.
■
Setting Loop Recording ([4K Burst(S/S)])
You can perform recording while deleting the oldest recorded data, allowing you to
keep on recording while waiting for a photo opportunity without replacing the card.
→ [Rec] → [4K PHOTO] → [Loop Recording(4K PHOTO)] → [ON]
• Once you start recording, the 4K burst file will be recorded and divided
approximately every 2 minutes.
Approximately the last 10 minutes (up to approximately 12 minutes) will be
saved. The preceding part will be deleted.
■
To cancel the 4K Photo functions
In step
2
, select [ ] ([Single]) or [ ].
●
When you perform [Light Composition] or [Sequence Composition], we
recommend using a tripod and taking pictures remotely by connecting the
camera to a smartphone to prevent camera shake. (→71)
To Next Page
Loading...
