EasyManuals Logo

Panasonic Lumix DC-TZ91 Basic Operating Instructions

Panasonic Lumix DC-TZ91
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
55
DVQX1237 (ENG)
Others
Striping or flicker may appear under lighting such as fluorescent lighting
and LED lighting fixture.
This is characteristic of MOS sensors which serve as the camera’s pickup sensors. This is
not a malfunction.
If you are taking still pictures using the electronic shutter, the striping may be reduced by
setting a slower shutter speed.
When noticeable flicker or striping is seen under lighting such as a fluorescent or LED lighting
fixture in the motion picture recording mode, you can reduce the flicker or striping by setting
up [Flkr Decrease] (44) and fixing the shutter speed. It is possible to select a shutter speed
from [1/50], [1/60], [1/100], or [1/120]. You can set the shutter speed manually in the Creative
Video Mode. (20)
No flash emitted.
The flash becomes unavailable in the following cases.
Flash set to [
] (Forced Flash Off).
Set [Shutter Type] to [AUTO] or [MSHTR]. (43)
Set [Silent Mode] to [OFF]. (44)
A Wi-Fi connection cannot be established. Radio waves get disconnected.
Use within the communication range of the wireless LAN network.
If any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency
are used nearby this unit simultaneously, radio waves may get interrupted.
Use them sufficiently away from the device.
When the battery indicator is flashing red, the connection with other equipment may not
start or the connection may be disrupted. (A message such as [Communication error] is
displayed.)
When this unit is placed on a metal table or shelf, the connection may not be established
easily because the camera is affected by radio waves. Use the camera away from metal
surfaces.
The lens makes a clicking noise.
When the camera is turned on or off, the lens is moved, or an aperture operation is
performed, such a noise may be heard. This is not a malfunction.
When the brightness changes after a zooming operation or moving the camera, the lens may
make a noise while adjusting the aperture. This is not a malfunction.

Other manuals for Panasonic Lumix DC-TZ91

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic Lumix DC-TZ91 and is the answer not in the manual?

Panasonic Lumix DC-TZ91 Specifications

General IconGeneral
BrandPanasonic
ModelLumix DC-TZ91
CategoryDigital Camera
LanguageEnglish

Related product manuals