257
Connecting with other devices
Storing recorded still pictures and motion pictures in
the recorder
You can connect the camera to a Panasonic Blu-ray recorder or DVD recorder and store
pictures from the camera on the recorder.
Preparations
• Turn on the camera and recorder.
1
Connect camera to recorder
• Check the plug direction and insert it straight in. (Inserting these at an angle may
cause deformation or malfunction) Also, do not insert into the wrong socket. Doing
so may cause damage to this unit.
• Use the supplied USB connection cable or a commercially available Type-C USB
connection cable that complies with USB standards. (Depending on the country
or area where the camera was purchased, the USB connection cable may not be
supplied with the camera.)
[USB/CHARGE] socket
USB connection cable
2
Dub by operating the recorder
• For details on dubbing and playback procedures, refer to the operating
instructions for the recorder.
• Some recorders may not support certain modes, such as the 4K motion picture
mode.
●
Take care not to turn off the camera while storage is in progress.
●
Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable.
To Next Page
Loading...
