Basic
- 52 -
• Use a battery with sufficient battery power when formatting. Do not turn the camera off during
formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
• If the card has been formatted on a PC or other equipment, format it on the camera again.
• It may take longer to format the built-in memory than the card.
• If you cannot format, contact the dealer or your nearest Service Centre.
• If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
• The Stabiliser function is switched between [On] and [Off] every time [MENU/SET] is pressed
during the [Stabilizer Demo.].
• [Stabilizer Demo.] is an approximation.
• [Auto Demo] is not output to the television.
[Version Disp.] It is possible to check which version of firmware is on the camera.
[Format]
The built-in memory or card is formatted. Formatting
irretrievably deletes all the data so check the data carefully
before formatting.
~ [Language]
Set the language displayed on the screen.
[Demo Mode]
Displays the amount of jitter the camera has detected. ([Stabilizer
Demo.])
The camera’s features are displayed as slide shows.
([Auto Demo])
[Stabilizer Demo.]:
A Amount of jitter
B Amount of jitter after correction
[Auto Demo]:
[ON]
[OFF]
DEMO
To Next Page
Loading...
