Recording
- 80 -
Entering Text
It is possible to enter babies’ and pets’ names and the locations when recording. (Only
alphabetical characters and symbols can be entered.)
Display the entry screen.
• You can display the entry screen via the following operations.
– [Name] of [Baby1]/[Baby2] or [Pet] in Scene Mode
– [Name] in [Face Recog.]
– [Location] in [Travel Date]
Press 3/4/2/1 to select text and then press
[MENU/SET] to register.
• Move the cursor to [ ] and then press [MENU/SET] to switch
text between [A] (capitals), [a] (lower case), [1] (numbers) and
[&] (special characters).
• To continuously enter the same character, move the cursor by
pressing [T] on the zoom button.
• The following operations can be performed by moving the cursor to the item and
pressing [MENU/SET]:
– []]: Enter a blank
– [Delete]: Delete a character
– [ ]: Move the entry position cursor to the left
– [ ]: Move the entry position cursor to the right
• The following characters and numbers can be entered.
Press 3/4/2/1 to move the cursor to [Set] and then press
[MENU/SET] to end text input.
Note
•
Text can be scrolled if all of the entered text does not fit on the screen.
• It is displayed in order of location, [Name] ([Baby1]/[Baby2], [Pet]), [Name] ([Face Recog.]).
– A maximum of 30 characters can be entered (Maximum of 9 characters when setting
names in [Face Recog.]).
¢ A maximum of 15 characters can be entered for [ ], [ ], [ ], [ ] and [ ]
(Maximum of 6 characters when setting names in [Face Recog.]).
To Next Page
Loading...
