35
(ENG) VQT3L33
Battery Charger (Panasonic DE-A60A):
Information for your safety
Battery Pack (lithium-ion) (Panasonic DMW-BCF10E):
Information for your safety
Crash resistance
perfomance
The test method of the camera is in compliance with
“MIL-STD 810F Method 516.5-Shock”
¢
.
¢ “MIL-STD 810F Method 516.5-Shock” is the test
method standard of the U.S. Defense Department,
which specifies performing drop tests from a height
of 122 cm (4.0 feet), at 26 orientations (8 corners,
12 ridges, 6 faces) using 5 sets of devices, and
passing the 26 orientation drops within 5 devices.
(If failure occurs during the test, a new set is used to
pass the drop orientation test within a total of 5
devices)
• Panasonic’s test method is based on the above
“MIL-STD 810F Method 516.5-Shock”. However, the
drop height was changed from 122 cm (4.0 feet) to
200 cm (6.6 feet) dropping onto 3 cm (0.10 feet) thick
plyboard. This drop test was passed.
(Disregarding appearance change such as loss of paint
or distortion of the part where drop impact is applied.)
There is no guarantee of not breaking or
malfunctioning under all conditions.
Dustproof
performance
Equivalent to IEC 60529 “IP6X”.
Input: 110 V to 240 V 50/60 Hz, 0.2 A
Output: 4.2 V 0.65 A
Operating
temperature: 0 oC
¢
to 40 oC (32 oF
¢
to 104 oF)
¢ The battery cannot be recharged in a temperature
less than 0 oC (32 oF). (The [CHARGE] indicator
blinks when the battery cannot be recharged.)
Voltage/capacity: 3.6 V/940 mAh
VQT3L33~Body3_eng.fm 35 ページ ２０１１年１月２８日 金曜日 午前１１時３６分
To Next Page
Loading...
