- 10 -
Before Use
1 Check that there are no foreign objects on the inner side of the side door.
•
If there is any foreign object, such as lint, hair, sand, etc., on the surrounding area, water
will leak within a few seconds causing malfunction.
• Wipe it off with a dry soft cloth if there is any liquid.
It may cause water leaks and malfunction if you use the camera with liquid adhered.
• If there is any foreign material, remove with supplied brush.
• Be extremely careful to remove the small sand etc. that may adhere to the sides and
corners of the rubber seal.
• Remove large foreign objects, wet sand, etc., using the shorter (harder) side of the brush.
A Brush (supplied)
B Side door
2 Check for cracks and deformation of the rubber seal on the side door.
•
The integrity of the rubber seals may decrease after about 1 year, with use and age. To
avoid permanently damaging the camera the seals should be replaced once each year.
Please contact Panasonic’s Service Centre for related costs and other information.
3 Close the side door securely.
•
Lock the [LOCK] switch securely until the red part is no longer visible.
• To prevent water seeping into the camera, be careful not to trap foreign objects such as
liquids, sand, hair or dust etc.
Check before using underwater
Do not open or close the side door in places with sand and dust, close to water, or
with wet hands. Sand or dust adhering may cause water leaks.
C: Red part
D: [LOCK] switch (grey part)
E: Released state
F: Locked state
To Next Page
Loading...
Need help?
General
Weight and Dimensions
