Recording
- 87 -
When the information acquired by the positioning is different from the current location, it is
possible to change it by selecting the desired location name or landmark from the
selectable candidates registered in the database of this unit.
Select [GPS Area Select] from the [GPS/Sensor] menu. (P44)
• Other location name information can be selected when [ ] is displayed.
Press 3/4 to select the item to change, and then press [MENU/SET].
Press 3/4 to select the location name or landmark from the
candidates, and then press [MENU/SET].
∫ When not storing the location name or the landmark in the recorded pictures
When not storing all the location name information:
Select [Delete all place-names] in above step
2
– Confirmation screen is displayed. All the displayed location name information is deleted and
the information will not be stored from the next time a picture is recorded when [Yes] is
selected.
When not storing specific location name information:
Select [Delete country], etc., in above step
3
– Confirmation screen is displayed. All the items inferior to the deleted item are deleted and the
information will not be stored from the next time a picture is recorded when [Yes] is selected.
(Example: When the [State/Prov./County] is deleted, [County/Township], [City/Town/Village]
and [Landmark] that are inferior to it are also deleted.)
Note
•
To restore the location name information deleted, set them again.
• When desired location name or landmark is not displayed among the candidates, perform
[My Landmark] (P88) before taking a picture, or perform [Place-Name Edit] (P126) after taking
a picture.
• Longitude/latitude is not deleted even when the location name or landmark is deleted. Turn
[GPS Setting] to [OFF] if you would not like to store the latitude/longitude.
Change the recorded place name information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
