Panasonic LUMIX DMC-FX3 - About the Built-In Memory (DMC-FX3)

Preparation
17
VQT0Y69
About the Built-in
Memory (DMC-FX3)
• The built-in memory is only available in
DMC-FX3.
∫ Built-in Memory [ ]
You can record or play back pictures on
the built-in memory when you are not
using a card.
• The built-in memory capacity is about
13.5 MB.
• Picture size is fixed to QVGA
(320k240 pixels) when recording
motion pictures to the built-in memory.
(P63)
∫ Card [ ]
You can record or play back pictures on
a card.
(The built-in memory cannot be used
when a card is inserted.)
∫ Access to the built-in memory or the
card
• The access indication lights red when
pictures are being recorded on the built-in
memory.
• Do not do the following when the access
indication is lit, pictures are being read or
deleted or the built-in memory is being
formatted (P90):
– Turn the camera off.
– Remove the battery or the card (if used).
– Shake or impact the camera.
– Disconnect the AC adaptor (DMW-AC5;
optional). (When using the AC adaptor.)
The card or the data may be damaged and
the camera may not operate normally.
Icons displayed on the screen:
A: When using the built-in memory
B: When accessing the built-in memory
C: When using the card
D: When accessing the card
• Picture data recorded on the built-in
memory or a card can be copied from
the built-in memory to the card or vice
versa. (P89)
• The built-in memory (about 13.5 MB)
can be used as a temporary storage
device when the card being used
becomes full.
• The data on the built-in memory or the
card may be damaged or lost due to
electromagnetic waves, static electricity or
breakdown of the camera or the card. We
recommend storing important data on a
PC etc.
• The access time for the built-in memory
may be longer than the access time for a
card. (Max. about 7 sec.)
3
()
()
VQT0Y69ENG.book 17 ページ ２００６年６月３０日 金曜日 午前１１時７分