Advanced (Recording pictures)
42
VQT1J59
Taking pictures that
match the scene being
recorded
(Scene mode)
When you select a scene mode to match
the subject and recording situation, the
camera sets the optimal exposure and hue
to obtain the desired picture.
• Refer to P43 to 49 and “About the
information ” for details about each
scene mode.
1 Move 3/4/2/1 to select the
scene mode.
•Move 4 at A to switch to the next
menu screen.
• You can switch menu screens from any
menu item by rotating the zoom lever.
2 Press [MENU/SET] to set.
• The menu screen is switched to the
recording screen in the selected scene
mode.
• To change the scene mode, press
[MENU/SET], then move 1, and repeat
steps
1and 2 above.
∫ About the information
• If you press [DISPLAY] when selecting a
scene mode in step
1, explanations about
each scene mode are displayed. (If you
press [DISPLAY] again, the screen
returns to the [SCENE MODE] menu.)
• Refer to P37 for information about the
shutter speed.
• The flash setting is memorized even if the
camera is turned off. However, the scene
mode flash setting is reset to the initial
setting when the scene mode is changed.
• When you take a picture with a scene
mode that is not adequate for the
purpose, the hue of the picture may differ
from the actual scene.
• When [MENU/SET] is pressed and the
menu screen is displayed, [ ] is
selected in the [SCENE MODE] menu.
You can set each of the settings by
moving 4 and selecting [REC] mode
menu [ ] or [SETUP] menu [ ].
• The following items cannot be set in scene
mode because the camera automatically
adjusts them to the optimal setting.
– [INTELLIGENT ISO]
– [SENSITIVITY]
– [COL.MODE]
A
DMC-FX33-BODY_mst.fm 42 ページ ２００７年７月１０日 火曜日 午後８時３６分
To Next Page
Loading...
