- 137 -
Connecting to other equipment
Note
•
This unit cannot stand upright when the AC adaptor is connected. When placing it on a surface
and operating it, we recommend placing it on a soft cloth.
• Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
• Turn the camera off before connecting or disconnecting the AC adaptor (optional).
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
• You cannot switch between the built-in memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
• Copy the pictures recorded in Clipboard Mode, copy them onto a card (P109), and then print
them out.
Selecting a single picture and printing it
Press 2/1 to select the picture and then press
[MENU/SET].
• The message disappears in about 2 seconds.
Press 3 to select [PRINT START] and then press
[MENU/SET].
• Refer to P139 for the items which can be set before starting to
print the pictures.
• Press [MENU/SET] to cancel printing halfway.
• Disconnect the USB connection cable after printing.
PictBridge
MULTI PRINT
100-0001
100-0001
PLEASE SELECT
THE PICTURE TO PRINT
SELECT
PRINT
OFF
1
CANCEL
SELECT
SET
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
SINGLE SELECT
To Next Page
Loading...
