Preparation
- 28 -
• This will work when the HDMI mini cable (optional) is connected.
• Refer to P146 for details.
• Use a battery with sufficient battery power or the AC adaptor (optional) and DC coupler
(optional) when formatting. Do not turn the camera off during formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
• If the card has been formatted on a PC or other equipment, format it on the camera again.
• It may take longer to format the built-in memory than the card.
• If you cannot format, contact the dealer or your nearest Service Centre.
[VIERA Link]
Setup so this unit can be controlled by the remote control of the
VIERA by automatically coupling this unit with the VIERA Link
compatible equipment using HDMI mini cable (optional).
[OFF]: Operation is performed with the buttons on this unit.
[ON]: Remote control operation of the VIERA Link
compatible equipment is enabled. (Not all operations
are possible)
Button operation of the main unit will be limited.
} [SCENE MENU]
Set the screen that will appear when a Scene Mode has been
selected.
[OFF]: The recording screen in the currently selected Scene
Mode appears.
[AUTO]: The [SCENE MODE] menu screen appears.
[VERSION DISP.]
It is possible to check which version of firmware is on the camera.
[FORMAT]
The built-in memory or card is formatted. Formatting irretrievably
deletes all the data so check the data carefully before formatting.
To Next Page
Loading...
