VQT1S39 (ENG)
12
Inserting and Removing the Card (optional)/the
Battery
• Check that this unit is turned off.
• Close the flash.
• We recommend using a Panasonic card.
Slide the card/battery door to open it.
• Always use genuine Panasonic batteries
(CGR-S006E).
• If you use other batteries, we cannot guarantee the
quality of this product.
Battery: Insert it fully being careful
about the direction you insert it. Pull
the lever A in the direction of the
arrow to remove the battery.
Card: Push it fully until it clicks
being careful about the direction
you insert it. To remove the card,
push the card until it clicks, then
pull the card out upright.
B: Do not touch the connection terminals of
the card.
•
The card may be damaged if it is not fully
inserted.
1:Close the card/battery door.
2:Slide the card/battery door to the end
and then close it firmly.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
Note
•
Remove the battery after use.
• Do not remove the battery while the power is on as the settings on the camera may not be
stored properly.
• The supplied battery is designed only for the camera. Do not use it with any other equipment.
• Before removing the card or battery, turn the camera off, and wait until the power lamp has
gone off completely.
(Otherwise, this unit may no longer operate normally and the card itself may be damaged or the
recorded pictures may be lost.)
DMC-FZ28PL-VQT1S39_mst.book 12 ページ ２００８年７月１５日 火曜日 午前９時４３分
To Next Page
Loading...
