VQT1S39 (ENG)
26
Press 3/4 to select [PC], and then press [MENU/
SET].
• If [USB MODE] is set to [PC] in the [SETUP] menu in advance,
the camera will be automatically connected to the PC without
displaying the [USB MODE] selection screen. Since there is no
need to set this each time you connect to the PC, it is
convenient.
• When the camera has been connected to the PC with [USB MODE] set to
[PictBridge(PTP)], a message may appear on the PC’s screen. Select [Cancel] to close
the screen, and disconnect the camera from the PC. Then set [USB MODE] to [PC]
again.
Double-click on [Removable Disk] in [My Computer].
• When using a Macintosh, the drive is displayed on the desktop. (“LUMIX”, “NO_NAME”
or “Untitled” is displayed.)
Double-click [DCIM] folder.
Using a drag-and-drop operation, move the pictures you want to
acquire or the folder storing those pictures to any different folder on
the PC.
∫ Disconnecting the USB connection cable safely
•
Proceed with the hardware removal using “Safely Remove Hardware” on the task tray of the
PC. If the icon is not displayed, check that [ACCESS] is not displayed on the LCD monitor of
the digital camera before removing the hardware.
USB MODE
SELECT
SET
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
MENU
DMC-FZ28PL-VQT1S39_mst.book 26 ページ ２００８年７月１５日 火曜日 午前９時４３分
To Next Page
Loading...
