17
• Step 4. Display the INITIAL SETTING:
While pressing [ MENU/SET ] and “[ RIGHT ] of Cursor buttons” simultaneously, turn the Power off.
The “INTIAL SETTINGS” menu is displayed.
There are two kinds of “INITIAL SETTINGS” menu form as follows:
[CASE 1. After replacing MAIN P.C.B.]
[Except "EG, EB, EC and EF" models : (VEP56158A is used as a Main P.C.B.)]
When MAIN P.C.B. has just been replaced, all of the model suffix are displayed as follows. (two pages in total)
[Only for "EG, EB, EC and EF" models : (VEP56158B is used as a Main P.C.B.)]
When MAIN P.C.B. has just been replaced, only 5 model suffix are displayed as follows.
[CASE 2. Other than "After replacing MAIN P.C.B."]
• Step 5. Choose the model suffix in “INITIAL SETTINGS”: (Refer to “CAUTION”)
[Caution: After replacing MAIN P.C.B.]
The model suffix can been chosen, JUST ONE TIME.
Once one of the model suffix have been chosen, the model suffix lists will not be displayed, thus, it can be changed.
Therefore, select the area carefully.
Select the area with pressing “[ UP ] / [ DOWN ] of Cursor buttons”.
To Next Page
Loading...
Need help?
General
