11
Connecting PC and Digital Camera
Only connect after installing the driver (P8).
The DMC-F7 is used for illustration of Digital camera
A To USB terminal
B To USB connection terminal
1
1 1
1
Install the driver in the PC (P8).
2
2 2
2
Insert the Memory card in the digital camera, and set to
playback mode.
3
3 3
3
Connect using the supplied USB cable.
Camera automatically changes to PC connection mode.
Please connect only after installing the driver. (P8)
≥When connecting, use the AC adaptor as the digital camera power
source.
¥When using a Macintosh PC, installation of the driver is not necessary.
¥When the status indicator of the digital camera is lit or flashing, please do not
disconnect the USB cable. The software may not function correctly and
damage the data being transmitted. Please refer to the digital camera
operating instructions.
¥During connection, if a message is displayed that the file is not found,
please see P36.
USB‑A.book11ページ２００２年１月２２日 火曜日 午後５時２９分
Downloaded from ManualsCamera.com Manuals
To Next Page
Loading...
Need help?
General
