- 94 -
Wi-Fi
∫ About the Wi-Fi connection lamp
∫ About the [Wi-Fi] button
(When connecting to a smartphone/tablet)
Press and hold [Wi-Fi], and release it after the Wi-Fi
connection lamp lights up.
• The information required for connecting the smartphone/tablet
to this unit (QR code, SSID and password) is displayed. (P97)
• If you press and hold [Wi-Fi] for too long, this unit may turn off. When this
occurs, turn on this unit again.
Pressing [Wi-Fi] before connecting to Wi-Fi
•
Following items can be selected.
Pressing [Wi-Fi] when using a Wi-Fi connection
•
Following items can be selected.
• Do not remove the memory card or battery or move to an area without any reception while
sending images.
• The monitor display may become distorted for an instant while connected to the service, however
this will not affect the image being sent.
Lit blue: The Wi-Fi connection is on standby
Blinking blue: Sending/receiving data through the Wi-Fi
connection
[New Connection] (P97)
[History Connection] (P119)
[Favorite Connection] (P119)
[Wi-Fi Setup] (P123)
[Terminate the Connection] Terminates the Wi-Fi connection.
[Change the Destination]
Terminates the Wi-Fi connection, and allows you to select a
different Wi-Fi connection.
[Change Settings for Sending
Images]
Refer to P122 for details.
[Register the Current
Destination to Favorite]
Registering the current connection destination or the
connection method, you can easily connect with the same
connection method next time.
[Network Address] Displays the MAC address and IP address of this unit.
Cancel
SSID:
Password:
Please set on your smartphone
Change method
Please scan the QR code using "Image App",
or enter the password into Wi-Fi settings
To Next Page
Loading...
