20 VQT3H43 VQT3H43 21
For details about the setting procedure in the [Setup] menu (→17)
Using the [Setup] menu (Continued)
Item Settings, notes
[Cust.Set Mem.]
Register settings on
current camera. (→51)
[C1] / [C2] / [C3]
[LCD Mode]
Make LCD monitor easier
to see.
[Auto Power LCD]:
The brightness is adjusted automatically depending on
how bright it is around the camera.
[Power LCD]:
Makes screen brighter than normal (for outdoor use).
[High Angle]:
Makes screen easier to see when taking pictures from
high positions. (becomes harder to see from the front)
[OFF]
• [Auto Power LCD] does not work in Playback Mode.
• [Power LCD] returns to ordinary brightness if there is no
operation for 30 seconds when recording. (Press any
button to make brighter again).
• [High Angle] will be canceled when power is turned off.
• Because the picture shown on the LCD monitor screen
emphasizes brightness, some subjects may look different
than their actual appearance, but this will not affect the
recorded picture.
• Setting [LCD Mode] will reduce the number of pictures
that can be recorded and recording time.
[Guide Line]
Select recording
information display and
types of guidelines. (→39)
[Rec. Info.]
[ON] (Display recording information with guide lines.)
[OFF]
[Pattern]
/ : Change the patterns of guide lines.
[Histogram]
Check subject brightness
on graph. (→39)
[ON]/[OFF]
Item Settings, notes
[Zoom Resume]
Remember the zoom
position when turning the
power off.
[ON]/[OFF]
• Cannot be set when using [Self Portrait] Scene Mode.
[Economy]
Turn off the power or
make the LCD monitor
go dark while not using
the camera to minimize
battery consumption.
[Sleep Mode]
[2 MIN.]/[5 MIN.]/[10MIN.]/[OFF]:
Automatically shut off power while not in use.
• To restore → Press the shutter button halfway, or turn on
the power again.
• Cannot be used in the following cases:
When using AC adaptor (optional) and DC coupler
(optional), when connected to computer/printer, during
motion picture recording/playback, during Slide Shows,
during automatic demo playback
• Settings fixed to [5 MIN.] in [Intelligent Auto] Mode.
[LCD Power Save]
[ON]/[OFF]:
The LCD monitor goes dark to minimize power
consumption.
• Reduces the picture quality of the LCD monitor display
during recording to minimize battery consumption
(except for the Digital Zoom area). Note, however, that
there is no effect on the recorded picture.
• The setting in [LCD Mode] is prioritized over the setting
in [LCD Power Save] for the brightness of the LCD
monitor.
[Auto Review]
Automatically display
still pictures immediately
after taking them.
[1 SEC.]/[2 SEC.]
[HOLD]: Auto review screen remains until a button (other
than the [DISP.] button) is pressed
[OFF]
• Fixed to [2 SEC.] in [Intelligent Auto] Mode.
• In [Panorama Assist], [Hi-Speed Burst], [Flash Burst],
and [Photo Frame] Scene Modes, or in [Auto Bracket],
and [Burst] Modes, Auto Review is performed regardless
of setting.
• Motion pictures cannot be automatically reviewed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
