FCC Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in
a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used
in
accordance with the instructions, may cause harmful interference to radio
communications. However, there
is
no guarantee that interference will not occur
in
a
particular installation. Ifthis equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or
more
of
the following
measures:
- Reorient or relocate
the
receiving
antenna.
-Increase the separation between
the
equipment
and
receiver.
- Connect the equipment into
an
outlet
on
a circuit different from that
to
which
the
receiver
is
connected.
- Consult the dealer or
an
experienced radio/TV technician for
help.
FCC Caution:
To
assure continued compliance, follow the attached installation
instructions and use only shielded interface cables with ferrite core when
connecting to computer or peripheral devices.
Any changes
or
modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Declaration
of
Conformity
Trade Name: Panasonic
Model No.: DMC-ZR1
Responsible party: Panasonic Corporation
of
North America One Panasonic
Way,
Secaucus,
NJ
07094
Support Contact: Panasonic Consumer Electronics Company 1-800-211-PANA (7262)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
(ENG) VQT2G33 3
To Next Page
Loading...
Need help?
General
