VQT4P14
Connecting with other devices
Keeping the still pictures and motion pictures on your PC
- 140 -
■
For PTP mode
The camera can be connected to your computer even if [USB Mode] (→50) is set to
[PictBridge(PTP)].
• Only picture output can be performed.
• If you cannot connect to your PC in PTP mode, set [USB Mode] to [PC] and
reconnect.
• It may not be possible to import if there are 1000 or more pictures on the card.
• Motion pictures or 3D still pictures cannot be read.
●
Do not use any other USB connection cables except the supplied one or a genuine
Panasonic USB connection cable (optional).
●
Turn off the camera before inserting or removing memory cards.
●
When the battery begins to run out during communication, a warning beep sounds.
Cancel communication via your computer immediately.
●
Setting the [USB Mode] to [PC] removes the need to make the setting each time the
camera is connected to the computer.
●
For more details, consult your computer operating manual.
■
Folder and file names on computer
You can save pictures to use on your computer by dragging and dropping folders and
files into separate folders on your computer. (except AVCHD motion pictures)
DCIM (Still/motion pictures)
100_PANA (Up to 999 pictures/folder)
P1000001.JPG
:
P1000999.JPG
101_PANA
:
*
1
999_PANA
MISC (DPOF files, Favorite)
PRIVATE
*
2
AVCHD (Motion pictures in AVCHD)
●
Windows
Drives are displayed
in “My Computer” or
“Computer” folder.
●
Mac
Drives are displayed on
the desktop.
(Displayed as “LUMIX”,
“NO_NAME”, or
“Untitled”.)
.JPG: Still pictures
.MP4: [MP4] Motion Pictures
.MPO: 3D still pictures
*
1
New folders are created in the following cases:
• When pictures are taken to folders containing files numbered
999.
• When using cards already containing the same folder number
(for example, pictures taken with other cameras, etc.).
• When recording after performing [No.Reset].
*
2
This folder is not created in the built-in memory.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
