Firmware Ver. 2.2 – [AF-Point Scope] Function Has Been Added
F-29
[AF-Point Scope Setting]
Changes the enlarged screen settings of AF-Point Scope.
[] [] Select [AF-Point Scope Setting]
• When the screen is enlarged, [AFC] changes to [AFS].
• When the following function is being used, AF-Point Scope does not work:
– [65:24]/[2:1] ([Aspect Ratio])
– Video recording/SH burst recording
[Keep Enlarged
Display]
Setting this to [ON] maintains the enlarged screen after pressing
the Fn button until it is pressed again.
[PIP Display]
Sets the display method (full screen mode
*1
/windowed mode
*2
)
of the enlarged screen.
*1 You can enlarge by approx. 3× to 10×.
*2 You can enlarge by approx. 3× to 6×.
To Next Page
Loading...
