Firmware Ver. 3.0 – SH Pre-burst Recording Function Has Been Added
F-54
3
Close the menu.
≥Press the shutter button halfway.
4
Start recording.
•
Pre-burst recording starts when the shutter button is pressed halfway.
•
Takes burst pictures while the shutter button is pressed fully.
Set Time Recorded Before Pressing Shutter Fully
[] [] [Burst Shot Setting] Select [SH Burst
Pre-Recording Time]
[1.5SEC]
Recording starts from 1.5 seconds before the shutter button was pressed fully.
[1.0SEC]
Recording starts from 1 second before the shutter button was pressed fully.
[0.5SEC]
Recording starts from 0.5 seconds before the shutter button was pressed fully.
•
The setting for [SH Burst Pre-Recording Time] is applied to both [Burst Shot 1
Setting] and [Burst Shot 2 Setting].
•
[PRE] is displayed on the recording screen during SH pre-burst recording.
•
If the shutter button is pressed and held at halfway for approx. 1 minute, the
frames before pressing fully cannot be saved. Press the shutter button halfway
again.
To Next Page
Loading...
