Panasonic MC-7650 - Power Control Switch; Rear Cover

Removing:
1. Remove the lock screw from the power control switch. Take
up the switch and cut off the lead wires. (MC-7650, 7630)
Assembling:
1. When placing a new power control switch, connect the lead
wires by coupling the wire connector or by soldering the
wires.
* To take out the MC-7610’s power control switch, remove
the screws.
The PCB Unit A is located below the power control switch.
Refer to the Exploded View [B] - Block.
Removing:
1. Remove the four screws and detach the rear cover.
Assembling:
1. Place and fix a new rear cover with the four screws.
Fig.12
Fig.13
9.6. Power Control Switch
9.7. Rear Cover
17
MC-7650 / MC-7630 / MC-7610