Panasonic MC-7650 - Cord Reel Assy

Removing:
1. Invert the main body to remove screws, and separate the
upper and lower bodies.
2. Take out the cord reel ass´y together with the body
partition.
3. Push the brake lever, and release the pre-winding. (Fig.16)
4. Remove the screw at the center to separate the cord reel
ass´y from the body partition. (Fig.17)
Assembling:
1. Install the cord reel ass´y on the body partition, using the
screw at the center. (Fig.17)
2. Pro-wind the cord reel ass´y 5 or 6 times in the direction of
the arrow (→) indicated on the cord reel cover. (Fig.16)
3. With the brake lever section down, fit the cord reel ass´y
into the upper body.
4. After positioning the lead wire between the motor and body
partition, couple the lower body.
Fig.16
Fig.17
9.10. Cord Reel Ass´y
20
MC-7650 / MC-7630 / MC-7610