Panasonic MX-AC300 - How to Use; Loading Ingredients and Setup; Operation and Lid Handling; Shutdown and Post-Use Procedures

12
3. Remove 4 pcs of M4 nuts and the truss tapping screw fixing Handle to Jar(Cup) in order to disassemble Blender
Jar Assembly, Mill Cup Assembly or Chutney Jar Assembly.
Assembly Instructions
a. Apply Silicone Adhesive Sealant(TSE382C) into
the screw holes(4 portions) of Cutter Base (U).
b. Cutter Base Packing B for Blender Jar is to be set in
the correct direction as shown in the figure. The
grooves b are to be in alignment with the holes a of
Cutter Base Cover.