EN8
Blender & Dry mill
Even turn to "1" or
"2" position, the
appliance
does not start
blending.
●
The blender jug
/
mill container is not set properly.
Make sure to align the marks on blender jug base
/
mill container and motor housing, then
twist it firmly until you hear a "click" sound.
●
The blender jug base
/
mill container base is not assembled tightly.
Assemble it tightly. (P. EN6)
●
The protection device of overload or overheating is activated.
Refer to "Overload and Overheating Protection" for inspection. (P. EN7)
●
The power plug is disconnected.
Insert the power plug into outlet firmly.
Rotation stops
abruptly.
●
The protection device of overload or overheating is activated.
Refer to "Overload and Overheating Protection" for inspection. (P. EN7)
There is abnormal
noise or vibration
increases.
●
Too much ingredients.
Reduce ingredient amount.
●
The blender jug base
/
mill container base is not assembled tightly.
Assemble it tightly. (P. EN6)
The ingredient is
leaking.
●
The blender jug base
/
mill container base is not assembled tightly.
Assemble it tightly. (P. EN6)
●
The blender gasket
/
mill gasket is not attached or attached loosely.
Attach it properly.
●
Foreign matters are attached to the blender gasket
/
mill gasket.
Remove them.
●
The blender gasket
/
mill gasket is damaged.
Contact Service Centre to replace it.
Blender
The blade is idling.
●
The liquid amount is not enough.
Add more liquid.
●
Too much ice cubes.
(e.g. juice with a lot of ice)
①
Remove blender jug after rotation stop completely.
②
Shake the blender jug gently.
When the blender is used When the dry mill is used
Power supply
220-240 V 50-60 Hz
Power consumption
MX-EX1511: 330-360
W /
MX-EX1561: 290-300
W
Rated time
Continuous operation
(
Repeat the cycle of 3 minutes ON and then
1 minute OFF
)
Continuous operation
(
Repeat the cycle of 1 minute ON and then 2
minutes OFF
)
Working capacity
(approximately)
1 500
mL
50
g
Dimensions (W x D x H)
(approximately)
MX-EX1511: 189x174x414 mm
MX-EX1561: 189x174x414 mm
163x174x268 mm
Mass. (approximately)
MX-EX1511:2.0
kg /
MX-EX1561:3.2
kg
1.6
kg
Before calling for service, please check through this section.
Problem Cause and Action
Troubleshooting
Specications
To Next Page
Loading...
