What to do if there are residues of detergent on the clothes after washing with my Panasonic Washer?
The pieces of some detergents which do not dissolve in water may stick to clothes as white stains. By calibrating the machine for the rinsing program, make an additional rinsing or eliminate the stains after drying with the help of a brush.
What to do if the door does not open on my Panasonic NA-148VB3?
If the door of your Panasonic Washer won't open, the door lock may be activated, so check if the door lock is activated. Alternatively, the water temperature or level may be too high; wait for the temperature or level to decrease.
Why is my Panasonic NA-148VB3 Washer machine not operating?
Your Panasonic Washer might not be operating due to several reasons. It could be unplugged, so ensure it is properly inserted into the socket. The fuse might be defective and needs changing. Check if you've pressed the Start/Pause button. Also, the program knob should be on the desired setting, not in the '0' (off) position. Ensure the door is properly shut until you hear a click. Finally, the child lock might be active; refer to section 6.5 for deactivation instructions.
Why is my Panasonic Washer not draining water?
If your Panasonic Washer isn't draining water, the drain hose might be obstructed or bent, so check it. Also, the pump filter could be obstructed, and it needs cleaning. Ensure that clothes are placed inside the machine in a well-balanced manner.
How to reduce excessive foam in my Panasonic Washer?
If there's too much foam in your Panasonic Washer, it could be due to the water's temperature, level, or softness. Try to ensure correct water conditions. You might also be using too much detergent, so reduce the amount. The type of detergent could also be the culprit, so consider changing to a low-foam detergent.
Why are there grey stains on the clothes after washing in my Panasonic NA-148VB3?
Grey stains on clothes after washing in your Panasonic Washer may be caused by oil, cream, or ointment. In the next washing operation, use the maximum detergent amount declared by the detergent producer.
Why is the washing result not good in my Panasonic Washer?
A not-so-good washing result in your Panasonic Washer can stem from a few reasons. You might have filled the machine with clothes exceeding its maximum capacity, so ensure you don't overload it. Hard water could be the culprit, so adjust the detergent amount as per the detergent producer's instructions. Also, make sure the clothes are spread evenly inside the machine for a well-balanced distribution.
Why does the spinning process start with delay on my Panasonic NA-148VB3?
The delayed spinning process in your Panasonic Washer is not a failure. The unbalanced load control system is designed to distribute clothes evenly. Once the clothes are distributed, the spinning process will begin. For the next wash, ensure clothes are placed in the machine in a well-balanced manner.
Why do foam and water remain in the door of my Panasonic NA-148VB3?
If foam and water remain in the door or door seal of your Panasonic Washer, although some foam and water might remain depending upon the state of the laundry and the amount of detergent used, the performance of the rinse cycle is unaffected, so no action is needed.
Why does fabric softener overflow in my Panasonic Washer?
If fabric softener overflows in your Panasonic Washer, it might be because the softener level exceeded the MAX level for the detergent drawer. Make sure you do not exceed the MAX level. You may have also spilled the liquid by closing the detergent drawer too strongly, so close the detergent drawer gently.
Safety guidelines for general operation, supervision, and potential hazards.
Safety instructions related to the power cord, plug, and electrical connections.
Warnings and precautions to prevent physical injury during operation or maintenance.
Cautions regarding improper use, connections, and handling of laundry.
Step-by-step guide on how to set up and start a wash cycle.
A table listing common problems, their causes, and solutions.
Explains error codes displayed on the machine and what actions to take.
General| Water consumption per cycle | 50 L |
|---|---|
| Energy consumption washing per cycle | - kWh |
| Door hinge | Left |
| Display type | LCD |
| Loading type | Front-load |
| Product color | White |
| Appliance placement | Freestanding |
| Timer | Yes |
| Drum capacity | 8 kg |
| Maximum spin speed | 1400 RPM |
| Noise level (spin) | 72 dB |
| Noise level (wash) | 53 dB |
| Number of washing programs | 16 |
Weight and Dimensions| Depth | 594 mm |
|---|---|
| Width | 596 mm |
| Height | 845 mm |
| Door opening diameter | 340 mm |
To Next Page
