50 51
When Necessary
Avoid the following locations for
installation.
• Location where water may get frozen in winter
(Washing cannot be done with frozen water.)
• Location exposed to direct sunlight
• Location where there is no window or ventilation fan
• Uneven or unstable location (on blocks, timbers,
bricks, table with wheels attached, etc.)
• Slippery location such as tile
When installing in an enclosed area,
keep the front open and secure gaps
from walls and ceiling with the indicated
dimensions or more.
3. Preparation before installation 4. Connect the hoses
2
Check the power
supply.
Use a dedicated socket rated
at 10 A and AC 220 to 240 V.
(Using in combination with other appliances
may cause fi re due to heat generation.)
• This appliance incorporates a dryer, thus
requires a socket rated 10 A or more.
Top
23 cm
Back
9 cm
Side
1 cm
Front open
Check the installation
location.
1
WARNING
WARNING
Attention
Do not allow the opening of the bottom of main unit
to be blocked by carpet, etc.
Do not allow lint, etc. to accumulate around the main
unit.
Do not allow the metal parts of the main unit to
electrically make contact with metal board in the
house, stainless board at the sink, etc.
Connect the hoses properly to prevent water leak.
Maximum connection distance of hoses and power cord
Installation
(continued)
Do not splash
water over the
appliance. Do
not install at a
damp place or
place which may
be exposed to
rain, water, etc.
(To prevent electric shock
or fi re)
WARNING
The appliance must not be
installed behind a lockable
door, a sliding door or a door
with a hinge on the opposite
side to that of the appliance,
in such a way that a full
opening of the appliance door
is restricted.
This will prevent children from being locked in
the drum.
Right side connections
Sink Sink
Water supply hose
Drain hose Drain hose
Drain outletDrain outlet
70 cm110 cm
100 cm 125 cm
Left side connections
90 cm 145 cm
Rise of
drain hose
(max. 100 cm)
Rise of
drain hose
(max. 100 cm)
Lengths shown are approximate.
To Next Page
Loading...
