26
Installation (continued)
4.
Connect the water supply hose.
.
CAUTION
z Do not make wrong
connection for the HOT and
COLD water supply faucets.
z Tighten the nut rmly.
z Do not twist, squash, modify or
cut the hose.
1
Attach one end of the water
supply hose to the water
supply valve screw.
1 Hold the elbow and tighten the nut.
2 Check that the elbow is not loose.
z The procedure for cold water and hot
water is the same.
2
Attach the other end of the water
supply hose (grey) to the cold water
tap, and tighten the nut clockwise
with your hand.
3
Likewise, attach the other end of the
water supply hose (white) to the hot
water tap.
4
Turn on the water taps slowly and
make sure there are no leaks.
Water supply
valve screw
NOTE
z If you have an uncontrolled water heating source (e.g., wet back, solar
heating), t a tempering device (e.g., a safe valve). This will ensure the hot
water temperature remains within safe limits. Contact a local plumber or
plumbing supply merchant for the most suitable type of tempering device.
z Time for hot water to reach washing machine will depend on proximity of
washing machine to hot water tank.
COLD
HOT
Water faucet
Water supply hose
To Next Page
Loading...
