Levelling the Machine
The lock nuts on all four feet must be screwed tightly against the housing.
1. Loosen the lock nut.
2. Turn the foot until it reaches the floor.
3. Adjust the legs and lock the nuts with a spanner.
Make sure the machine is level using a spirit level.
Connect the Water Supply Hose
To prevent leakage or water damage, follow the instructions in this chapter.
• Do not kink, crush or modify water inlet hose.
Connect the water
supply hose to the
water inlet valve and a
water tap with cold
water as indicated.
• Connect manually, do not use tools. Check if the connections are tight.
•
•
•
Do not kink or protract the drain hose.
Position drain hose properly ,otherwise damage might result in water leakage.
It is not allowed to remove the buckle of drain pipe.
PRODUCT INSTALLATION
NOTE
Drain Hose
11
WARNING
WARNING
WARNING
To Next Page
Loading...
