- 11 -
How to Operate
Programming
-
DO NOT OPEN THE DOOR
-
The Display Window MUST be blank before programming can begin. If any indicator light is
illuminated in the digital Display Window: Close the door, press STOP/RESET Pad and wait 1 minute
until the Display Window goes blank.
Display Window
A. Programming Memory Pads for Single Stage Heating:
Example: To program 30 seconds at Medium Power for Memory Pad Number 5
Display Window
1.
• Press the PROG. Pad.
NOTE:
• If no PROG. Indicator appeared in the
Display Window, "Program Lock" should be
cancelled. (See page 14.)
• Do not keep pressing PROG. Pad for more
than 30 seconds, or a false failure code
may result.
2. • Press Memory Pad 5.
The pad number and the previously
selected time and power level will appear in
the Display Window.
• The pad number and Stage Heating
Indicator will appear in the Display Window
again.
3.
• Press the Power Level Selector Pad 3
times. The Memory Pad display will go out.
4.
• Press Memory Pads 3 and 0.
5. • Press the PROG. Pad again.
You have completed programming the
selected Memory Pad for single stage
heating and double heating time for multiple
portion heating automatically.
• 2 seconds later, the time and power level
setting for single stage will appear in the
Display Window.
• 2 seconds later, Double Quantity (x 2)
Heating Indicator and then the double
heating time will appear in the Display
Window.
• 2 seconds later, the Display Window will go
blank.
IP5102_3BS80RP_Eng_10_150121.indd 11IP5102_3BS80RP_Eng_10_150121.indd 11 2015-1-21 10:00:342015-1-21 10:00:34
To Next Page
Loading...
Need help?
General
