Panasonic NE-1257R - Programming Double or Triple Quantity; Program Lock

How ta. Op Operate
D. PROGRAMMING DOUBLE OR TRIPLE QUANTITY PAD
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see page 11-12)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Beli] olism com elcejele-litme mem Ciii(-t-me)l macsr-l (ale melii-mielmelelelei-Mmeder-lnelamralcemy [elierel-leiii(-lile] am er: 16 mae
|
|
PAD
INSTRUCTION
DIGITAL
DISPLAY
WINDOW
Keep the door closed.
# Digital Display Window must be blank.
Press Prog pad.
# “PROG’ will start to blink.
Press Number/Memory pad “5S”.
The selected pad number will appear and currently programmed
information will be indicated.
Press Double Quantity pad.
# The currently programmed magnification number will appear.
Note: 1.6 times is preset at factory.
Press Number/Memory pads “1” and “5” for 1.5 times.
# The programmed magnification number will appear.
lf pad 5 is programmed for 3 minutes, the time for the double quantity
will be 4 minutes and 30 seconds.
Available range is 0.1-5.0 times.
Press Prog pad.
@ “PROG” will stop blinking.
This means that you have completed programming.
Note:
« If you want to program your desired magnification number for triple quantity, repeat as above, using Triple
Quantity pad instead of Double Quantity pad.
E. PROGRAM LOCK
@ To Activate Program Lock:
|
|
PAD
|
INSTRUCTION
DIGITAL
DISPLAY
WINDOW
Keep the door closed.
# Digital Display Window must be blank.
Press Prog pad until “PROG”, “P” and “L” appear. (more than five
seconds)
w# “PROG”, “P” and “L’ will appear.
In Program Lock mode:
¢ The oven is started by pressing the desired Number/Memory pad. There is no need to press Start pad.
¢ Opening the door cancels the remaining time on the program.
* The oven can not be programmed or run manually until the program lock is released.
-11-