Panasonic NE-1257R - Beep Tone Settings

How to Operate
@ To Release Program Lock:
as
INSTRUCTION
DIGITAL
DISPLAY
WINDOW
Open the door and leave it open.
# The oven lamp will turn on, and “O” will appear.
reset | + “P” appear. (more than five seconds)
ae While pressing Stop/Reset pad, press Prog pad until “PROG” and
# “PROG” and “P ” will appear.
In Program Unlock mode:
* Oven reverts to a two-touch operating mode (Number/Memory pad + Start pad).
¢ Repeat and interrupt feature are operational.
¢ Number/Memory pads can be programmed.
* Tone loudness control and length control are operational.
F. BEEP TONE
The loudness of beep tone and the length of beep tone There are two options of the length of beep tone at the
at the end of heating cycle can be set. end of heating cycle. The length is indicated by 1 st or
There are four levels of the loudness. The level is 2 nd Stage Heating Indicator.
indicated by a number followed by the word “bEEP”. 1 =3 beeps
SbEEP = loudest 2 = short beeps for 60 seconds
2bEEP = middle The loudest level and 3 beeps are preset at the factory.
1bEEP = quietest
ObEEP = silent
@ To Select Loudness Level and Length “3 beeps”:
Example: To select loudest beep tone
| | PAD | INSTRUCTION DIGITAL DISPLAY WINDOW
Open the door and leave it open.
# The oven lamp will turn on and “O” will appear.
ed — =
Press Number/Memory pad “0” once.
* The tone will sound at its loudness level and the loudness level “3”
followed by the word “bEEP” will appear. “PROG? will start to blink and
ist Stage Heating Indicator “1” (the length of beep tone “3 beeps”) will
be indicated.
Note: Repeating to press the pad “0” will lower the loudness all the way
to silent. (8 bEEP — loudest, 2 bEEP — middle,
1 bEEP — quietest, and 0 DEEP — silent)
Press Prog pad.
# “PROG’ will stop blinking. That means that you have completed
program.
Three seconds jater, “O” will appear.
¢ Close the door. One minute later, Digital Display Window will go blank. C7