Panasonic NE-1257R - Program List; Cycle Counter

How to Operate
# For selecting length of tone “short beeps for 60 seconds”:
Example: To select short beeps for 60 seconds
| | PAD INSTRUCTION DIGITAL DISPLAY WINDOW
Follow step 1-4 on page 12. DO NOT CLOSE THE DOOR!
Within three seconds after pressing Prog pad at step 4, press
Number/Memory pad “0” once.
# “PROG’ will start to blink and 2nd Stage Heating Indicator “2” (the
length of beep tone “short beeps for 60 seconds”) will be indicated.
Press Prog pad.
# “PROG’ will stop blinking. This means that you have completed
programming.
Three seconds later, “O” will appear.
*« Close the door. Digital Display Window will go blank.
G. PROGRAM LIST
INSTRUCTION
Open the door and leave it open.
# The oven lamp will turn on and “0” will appear.
While pressing Stop/Reset pad, press Start pad.
# Ail currently programmed information (the program set into each
Number/Memory pad (A/B sides), Beep Tone, and Program Lock
information) will continuously appear.
H. CYCLE COUNTER
@ To Check The Number Of Cycles That The Oven Has Been Used In Manual Mode:
Open the door and leave it open.
a The oven lamp will turn on and “0” will appear.
stor: |. troen | While pressing Stop/Reset pad, press Power Level Selector pad.
reset] |e | | « The number of cycles that the oven has been used in manual mode
will appear.
-13-